Description The Micro-Mesh MX90 Metal Polishing Kit will finish up to 30 square feet of metal. Use on stainless steel, copper, brass, aluminium and more. MX MICRO-MESH has a slightly stiffer backing enabling you to polish harder metal surfaces to a mirror finish. Micro-Mesh MX90 Metal Polishing Kit include 1 of each of the following: 60MX Micro-Mesh Sheet 6″x3″ 80MX Micro-Mesh Sheet 6″x3″ 100MX Micro-Mesh Sheet 6″x3″ 120MX Micro-Mesh Sheet 6″x3″ 150MX Micro-Mesh Sheet 6″x3″ 180MX Micro-Mesh Sheet 6″x3″ 240MX Micro-Mesh Sheet 6″x3″ 320MX Micro-Mesh Sheet 6″x3″ 360MX Micro-Mesh Sheet 6″x3″ 400MX Micro-Mesh Sheet 6″x3″ 600MX Micro-Mesh Sheet 6″x3″ 800MX Micro-Mesh Sheet 6″x3″ 1200MX Micro-Mesh Sheet 6″x3″ 3″x3″ Foam Block 100 MX / 150 MX Micro-Mesh Flexi-File 180 MX / 240 MX Micro-Mesh Flexi-File 400 MX / 600 MX Micro-Mesh Flexi-File Instructions For more details on Micro-Mesh and it’s uses, click here. Have a question or query? Contact Us MICRO MESH THE NON ABRASIVE ABRASIVE Conventional sandpaper is designed to be aggressive so that it will dig deeply. In its manufacture, the crystals are electrically charged so that they will stand up. They are locked into a hard resin and when applied to a surface it will literally tear in and remove the substrate of the material you are sanding. The crystals cut in a negative raking motion, leaving inconsistent scratch patterns. Micro Mesh does the opposite: The backing is a long lasting cloth to which an ultra flexible cushioning layer is applied. This cushioning layer will determine how far you can push the crystals before they will penetrate the cushioning layer. On top of this layer, is a very resilient glue and not a hard resin, but a completely flexible glue that will hold the crystals while allowing it to move and rotate. The crystals can turn in any direction without coming loose. When you start to apply pressure to sand with Micro-Mesh, the crystals will go into the cushioning layer while beginning to cut a bit. If you push harder, they will go further into the cushioning layer, which serves as a safety valve. It determines how much pressure you can exert in a downward direction. Instead of a deep scratch that sandpaper makes, Micro-Mesh produce a refined scratch that is close to an RMS of 1.0. The cushioning layer also allows the crystals to cut with a planning motion that leaves an extremely consistent scratch pattern and allows you to achieve extraordinary levels of gloss. In conclusion, Where conventional abrasives will take surfaces down 2 or 3 thousandths (.002 or .003), Micro-Mesh™ will take it down one ten-thousandth (.0001) or less.
